Many WRX parts For Sale
08-04-2004 | 10:46 PM
#1
Thread Starter
Registered User
Joined: Apr 2003
Posts: 26
From: West Palm Beach, FL
Many WRX parts For Sale
I'd like to try to get rid of most of this stuff soon if possible. Everything off 02' WRX w/ about 35k miles unless otherwise mentioned. Make offers on the following, I would prefer paypal.
Factory 02' WRX parts:
-Turbo back(downpipe, midpipe, axle back, etc, w. hangers)
-airbox, resonator, rubber accordian tube between maf and turbo inlet pipe SOLD!! resonator still for sale
-turbo inlet pipe w/ top plastic vacuum fitting snapped off
-springs
-fog lights(driver side has small chip but sill works fine, passenger side is fine) SOLD!!
-Entire A/C system from head to toe
-fuel pump
-air splitter
-coolant overflow tank
-clutch assembly(disk,pressure plate,cover,TOB)good shape face looks fine SOLD!!
-spare tire
-many factory rubber hoses and lines, etc.
-stock 16" wheels good shape minor scratch on one, w/ Firestone Indy 500 all season tires w/ 5k miles(tread is fine and these are actually much better than stock all around)
Other parts:
-Subaru rear diff. protector with all mounting hardware(few scratches on bottom, otherwise looks fine)
-K&N panel filter for stock box used for less than 10k miles
-4 brand new STI spark plugs in box, same as seen here http://www.kastleskorner.com/store/...products_id=401
-52mm Greddy EGT gauge only, no wiring & thermocoupler(white face)
-Nitrous Works single fogger wet NOS system. all brand new in packaging. Also have nitrous safety system which has a fuel and oil pressure sensor that will de-activate the system if anything drops below normal levels. Also has a nitrous safety valve that will vent the nitrous if the solenoid should stick open, or if something should go wrong. Also have brand new edelbrock purge kit with everything necessary for install. Another cool thing about this system is that it vents the ntirous between the solenoid and the fogger nozzle every time the throttle is released(i.e. shifting gears), it vents it through another line just like the purge.
Everything included for install in any subaru or almost any fuel injected car. Looking to sell as a package. 10lb bottle is full. Paid over $900 for everything.
-02' USDM EJ20 shortblock w/ 12k miles after rebuild. Motor spun a rod bearing, and I pulled it immediately thereafter. Built with JE stock bore pistons and rings, Eagle H-beam rods, and a cleaned up crank. Make offers, like to sell shortblock as a whole if possible
Many or most pics here, more to be added soon. http://www.imagestation.com/album/?id=4286403719&idx=29
More parts most likely to be added soon. Let me know if you have any questions.
-AK
Factory 02' WRX parts:
-Turbo back(downpipe, midpipe, axle back, etc, w. hangers)
-airbox, resonator, rubber accordian tube between maf and turbo inlet pipe SOLD!! resonator still for sale
-turbo inlet pipe w/ top plastic vacuum fitting snapped off
-springs
-fog lights(driver side has small chip but sill works fine, passenger side is fine) SOLD!!
-Entire A/C system from head to toe
-fuel pump
-air splitter
-coolant overflow tank
-clutch assembly(disk,pressure plate,cover,TOB)good shape face looks fine SOLD!!
-spare tire
-many factory rubber hoses and lines, etc.
-stock 16" wheels good shape minor scratch on one, w/ Firestone Indy 500 all season tires w/ 5k miles(tread is fine and these are actually much better than stock all around)
Other parts:
-Subaru rear diff. protector with all mounting hardware(few scratches on bottom, otherwise looks fine)
-K&N panel filter for stock box used for less than 10k miles
-4 brand new STI spark plugs in box, same as seen here http://www.kastleskorner.com/store/...products_id=401
-52mm Greddy EGT gauge only, no wiring & thermocoupler(white face)
-Nitrous Works single fogger wet NOS system. all brand new in packaging. Also have nitrous safety system which has a fuel and oil pressure sensor that will de-activate the system if anything drops below normal levels. Also has a nitrous safety valve that will vent the nitrous if the solenoid should stick open, or if something should go wrong. Also have brand new edelbrock purge kit with everything necessary for install. Another cool thing about this system is that it vents the ntirous between the solenoid and the fogger nozzle every time the throttle is released(i.e. shifting gears), it vents it through another line just like the purge.
Everything included for install in any subaru or almost any fuel injected car. Looking to sell as a package. 10lb bottle is full. Paid over $900 for everything.
-02' USDM EJ20 shortblock w/ 12k miles after rebuild. Motor spun a rod bearing, and I pulled it immediately thereafter. Built with JE stock bore pistons and rings, Eagle H-beam rods, and a cleaned up crank. Make offers, like to sell shortblock as a whole if possible
Many or most pics here, more to be added soon. http://www.imagestation.com/album/?id=4286403719&idx=29
More parts most likely to be added soon. Let me know if you have any questions.
-AK
Last edited by AK'S REX; 08-09-2004 at 07:35 PM.
08-05-2004 | 06:53 PM
#5
Thread Starter
Registered User
Joined: Apr 2003
Posts: 26
From: West Palm Beach, FL
Lemme check shipping on that midpipe. I really have no idea. I'd say about $50 obo plus shipping. I really dont know, lemme know what you think and I'll get some dimensions and check on shipping. Whats your zip?
I have a tentative offer on the diff protector for $30 plus shipping. Which I imagine cant be more than $10 Fedex ground.
-Adam
I have a tentative offer on the diff protector for $30 plus shipping. Which I imagine cant be more than $10 Fedex ground.
-Adam
Thread
Thread Starter
Forum
Replies
Last Post
silver_rex_4eat
Subaru General
2
03-09-2003 01:07 PM