Hello all,
I am changing springs from Tanabe gf210's to Tein H tech springs, now I had to cut the bump stops for the tanabe's but since my japanese isn't so good I cut 3/4 of an inch of the front and back(15-25mm was the measurement). The Teins are nicer and spell out what they want you to cut off. I was able to get a front bump stop to measure against so that is ok, but the dealer I went to was not able to find a rear anyplace! They seem to be on back order everywhere they looked. So does anyone have one laying around or doing a sping install they could measure for me? If all else fails I'm just going to go with the 3/4 of an inch I'm sure I cut since I just went equal cuts on the fronts and backs I have on the car now. Thank you!