how much more would it be to have you change this over to a 3 bolt?

 

Depends on how much the flange costs, Id need a gasket to either scan the gasket here and send him the pdf to transfer over into cad and then burn the flange or send him a gasket and have him do it all.

3/8" mild steel doesnt warp and move like stainless does and is preffered material to use, or you can use 1/2" and thicker stainless flange.

Cost shouldnt be too much since my laser guy doesnt screw me for one offs like the big local company I use for larger qty.

 

do you happen to have any gaskets for a gtspec manifold sitting around? I could send ya one if you dont. lmk, interested in the uppipe and downpipe. I can send you half the money now and the other half when its all done. lmk thanks

 

I dont but i think i traced the flange though...you either send me one, or i can buy and send a new grimmspeed gasket to the laser guy and just give you the new gasket afterwards, either way is fine with me.

 

PM' me your address and i'll send you the gasket. thanks

 

pm'd you....also what material do you want to go with? 3/8" mild steel or 1/2" 304ss?

 

bumping this up

 

Whatever you prefer Kelly.

 

ok the 3/8" mild with most likely be cheaper but be just as good as the 1/2" stainless. I should have the flange mid january, i gave him a heads up that im going to send him another gasket

 

still got this......tired of having to step over it.

 

bump...