Official: VALLEJO STARBUCKS MEET, Tuesdays @ 5:30 PM
08-17-2010 | 04:23 PM
I came to the meet up last week for the first time (I am a new WRX owner) and everyone I met out there was super chill and welcoming.....just wondering if everyone is meeting up again tonight?
08-17-2010 | 04:30 PM
Registered User
Joined: Jun 2009
Posts: 3,739
From: Brooklyn, NY
Car Info: Porsche 911
this should be a good semester
08-17-2010 | 05:29 PM
Registered User
Joined: Jun 2009
Posts: 3,739
From: Brooklyn, NY
Car Info: Porsche 911
Maybe this could apply to 06-07 (Hawk Eye) STi
This DIY is for 99-01 911 996 Litronic Xenon headlamps/headlights
Unlock your headlights by using the tool key (female allen wrench) on the side. Use manuals for help.
Unscrew these 2 screws then pull the white box out of the way.
Once the white box is out of the way you can see behind the projectors. There should be (3) star bit screws (T-20 with security hole)
Make sure to mark the (TOP) just so you don't get confused when you put it back together.
Unscrew 4 star bits around the projectors
Clear coat it then bake for 15 mins at 250 degrees then wait the next day to wet sand and buff.
Wet sand all around until everything looks dull.
Use this 3M products
Mothers ball polisher after compound
Compound (by hand) then polish (with mothers ball)
Crystal clear finish.
Factory lens with frosty finish
Factory lens with clear coat and buffed finish
***NOTE*** This particular picture is not a Porsche projector. I'm showing a RX330 lens with FROST/ROUGH finish. That's why the cut off line isn't sharp on some factory lens. Only some comes factory clear such as TSX S2000 300ZX and some other cars.... *** IF YOU LOOK CLOSELY ON THIS LENS IT'S NOT CLEAR AT ALL. ***
ENJOY!
This DIY is for 99-01 911 996 Litronic Xenon headlamps/headlights
Unlock your headlights by using the tool key (female allen wrench) on the side. Use manuals for help.
Unscrew these 2 screws then pull the white box out of the way.
Once the white box is out of the way you can see behind the projectors. There should be (3) star bit screws (T-20 with security hole)
Make sure to mark the (TOP) just so you don't get confused when you put it back together.
Unscrew 4 star bits around the projectors
Clear coat it then bake for 15 mins at 250 degrees then wait the next day to wet sand and buff.
Wet sand all around until everything looks dull.
Use this 3M products
Mothers ball polisher after compound
Compound (by hand) then polish (with mothers ball)
Crystal clear finish.
Factory lens with frosty finish
Factory lens with clear coat and buffed finish
***NOTE*** This particular picture is not a Porsche projector. I'm showing a RX330 lens with FROST/ROUGH finish. That's why the cut off line isn't sharp on some factory lens. Only some comes factory clear such as TSX S2000 300ZX and some other cars.... *** IF YOU LOOK CLOSELY ON THIS LENS IT'S NOT CLEAR AT ALL. ***
ENJOY!
