Water temp gauge install help
07-31-2004 | 11:28 AM
#1
Guest
Posts: n/a
Water temp gauge install help
Am installing a temp gage in my 2004 WRX. Firt off where is the gage sending unit, from what i see or think it is below the alternator and hard to get to. where else can I mount the sending unit for the new gage. I am thinking about splicing the upper radiator hose and putting the sensoe there. sombody mentioned putting it into the radiator drain plug, but that would not give me a true reading. ANY HELP WILL BE APPRECIATED!!!
07-31-2004 | 11:37 AM
#2
VIP Member
Joined: Nov 2002
Posts: 1,646
From: NYC
Car Info: 02 WRX WRB
Do NOT disturb the existing factory temperature sender or attempt to tap it electrically. It is not just used by the gauge in the dash, it is also used by the ECU to determine coolant temperature. If you do anything to affect its signal to the ECU the car will run very badly.
You need to install the sender for your new gauge in a different location.
It would also help if you provide more information on the specific gauge you have, and the type of sensor it came with. This will allow more accurate advice to be given. You can also search for threads about this type of install, it's been done and discussed many times before. Look on NASIOC too.
You need to install the sender for your new gauge in a different location.
It would also help if you provide more information on the specific gauge you have, and the type of sensor it came with. This will allow more accurate advice to be given. You can also search for threads about this type of install, it's been done and discussed many times before. Look on NASIOC too.
Thread
Thread Starter
Forum
Replies
Last Post
STi4WRC
Engine/Power - EJ25T (STI and 2006+ WRX)
2
07-06-2008 03:35 AM
bambams247
Interior, Exterior & Lighting
1
08-21-2003 09:34 AM
