Good Idea? Or Bad Idea?
#5
I think it looks ok, from the angle in the pic the wagon wing doesn't look to big. Do you have any other pics from different angles?
I am guessing its mounted to the roof, not sure how well the fitment will be. Just make sure it don't leak.
I am guessing its mounted to the roof, not sure how well the fitment will be. Just make sure it don't leak.
#8
The top spoiler on the sedan is different the spoiler in the lower picture.
I beleive that the spoiler you would want to use would be from an older Forester or OBS.
Something like this - you may have to trim it to fit properly.
I beleive that the spoiler you would want to use would be from an older Forester or OBS.
Something like this - you may have to trim it to fit properly.
#9
Guest
Posts: n/a
Resurrecting this thread from the dead with a call for opinions since my thinking is relatively close...
What about going with something like combining a roof spoiler (something flat, not arched like the erebuni) with a Mines rear trunk lip/spoiler?
Thoughts? Photochop, maybe?
What about going with something like combining a roof spoiler (something flat, not arched like the erebuni) with a Mines rear trunk lip/spoiler?
Thoughts? Photochop, maybe?
#10
VIP Member
iTrader: (2)
Join Date: Nov 2002
Location: Under your bed, in your closet, and in your head
Posts: 15,425
Car Info: Corvette Z51
^^^
I think that'd look pretty weird... I mean, two lip spoilers on different parts of the car is bound to look funky right? Not to mention that they might cancel each other out aerodynamically. Just my 2 cents
I think that'd look pretty weird... I mean, two lip spoilers on different parts of the car is bound to look funky right? Not to mention that they might cancel each other out aerodynamically. Just my 2 cents
Thread
Thread Starter
Forum
Replies
Last Post
aroggio
Engine/Power - EJ25T (STI and 2006+ WRX)
5
07-21-2005 08:30 PM
Rumplestilzchen
Suby Shopping & Maintenance/Warranty
1
09-13-2004 09:48 PM
UNKLESKELETOR
Engine/Power - EJ20T (pre-2006 WRX and JDM)
1
05-01-2003 10:06 PM