05 sti guage cluster into an 03 wrx... anyone done it? HELP!!!
#1
05 sti guage cluster into an 03 wrx... anyone done it? HELP!!!
ok i found the threads on how to do it!!! but some confusion when reading the instructions!!!
this is the second link below:
when he talks about grounding pin 4 how do i do that? would i take the b4 wire from the connector and ground it that way? im lost with this one there are no pictures to go along with it....
and with this one has anyone rewired the circuit on the board?
i really don't want it to look tacky with a piece of tape over it...
its a very good write up but he has left a few of the aspects astray and of course i got confused on them!!!????
i need help!!!
http://forums.nasioc.com/forums/show....php?t=1166573
http://forums.nasioc.com/forums/showthread.php?t=926620
thanks,
Trevor
when he talks about grounding pin 4 how do i do that? would i take the b4 wire from the connector and ground it that way? im lost with this one there are no pictures to go along with it....
Step 5 is the ABS Light. At this point, no good solution has been found. I taped it and left a LITTLE of the bottom of the A showing so that if the ABS DOES fail, I'll see the little yellow light go off. The solution involves backwards wiring the ABS circuit on the board to be OFF all the time until failure.
i really don't want it to look tacky with a piece of tape over it...
its a very good write up but he has left a few of the aspects astray and of course i got confused on them!!!????
i need help!!!
http://forums.nasioc.com/forums/show....php?t=1166573
http://forums.nasioc.com/forums/showthread.php?t=926620
thanks,
Trevor
Last edited by Subadubaru; 10-17-2009 at 02:29 PM.
#3
Yes, the prong on the plug (from ur car) is preventing the plug from going into the gauge cluster. You need to file/cut down the prong that is holding it back. Then it should work.
#5
04 are plug and play, but you will have some electrical polarity problem. I forgot which but ur ABS i believe will have opposite polarities, so it will always be on or something like that. Just shave that part of the A clipp and everything is dandy.
Thread
Thread Starter
Forum
Replies
Last Post
Funks
NorCal Classifieds
9
02-05-2014 10:32 PM
LOL_VTEC
NorCal Classifieds
3
06-11-2009 01:42 AM
supermoose
NorCal Classifieds
13
06-26-2007 11:50 AM
JRsWRX
New Aftermarket Car Parts For Sale
0
03-13-2006 03:56 PM
rebbaz
NorCal Classifieds
0
01-22-2005 08:52 PM