Aiight so i got a new clutch finally.......I'm willing to trade beer and pizza for knowledge and wrench time which will be this thursday if things go right.

also i need to know where i can get my flywheel refaced.....or if someone has a lightweight one i can buy let me know. i also believe i need to pick up a throw out bearing, pilot bearing, and fluid. If you know anything please put your .02Cents in. THANKS!!

 

i have no knowledge, but ill sure put in some wrench time for some beer/pizza. (heines and ham/pineapple preffered)

 

Yo check your PMs. I remembered to send the link!

 

thanks brands your sexy points went up a knotch

 

the clutch job is not a easy one it will require alot of time and someone will need to be there to help you at all times cause things need to be done frome the top and bottom at the same time if you have access to a lift it will be about a 2 day job at about 8 hrs a piece if you have never done it before. Mario and I did his clutch and flywheel in 8 hrs, only after it took us about 6 days on my sti's clutch so we knew exactly what to do and how to do it. your gonna need access to alot of tools that can help to get the job done. Go to snyders in waipahu to get you flywheel resurfaced it think its only like $50 or so. Check out this link for more help http://home.nycap.rr.com/tmat3/clutch.html

 

ive looked over the directions via brandy, how come it takes two 8 hour days, it doesnt look that hard, but then i could be shootin the mouth again. I think for everyone's benefit i will document this swap, ill even take pics, thanks for the info
P.S. i do have a little experience.

 

It took me 3 days, once to take it apart and just look at everything and 2 to actually do the swap. I doubt I worked 8 hours straight on mine, maybe more like 5-6 hours each day. Either way, it was my first time on this car but I did have a trans jack that I borrowed. Good luck with it Boobie

 

your not comming......o.......ya know the whole purpose of having cell phone is to answer it

 

Ditto, i called your **** back!

Can't come on a Thursday man.

 

do you (brandy) think bobbay needs a lift or is jack stands and a trans jack sufficient. not to sound pessimistic bobby, but it looks like this wont be done in one day...

 

frick im tired, i started the tear down for the install of my new clutch, i got as far as drive axle and the plug that requires a 10mm hex wrench which i dont have, thought i did, but everything else is good to go. So yeah 2hrs and 45min tonight, not too bad, not really hard yet as it is a pain in the ****, and boring too. anyways if anyone is interested ill be wrenching on this tomorow morning til 100 in the after noon or so, then i gotta go to work. then all day thursday til its done. food and drink are on me. feel free to drop by!!!

 

anyone know any tricks to get the transmission off the block, i can get it to budge.

 

ur screwed. hehe...hope it goes well man.

 

you know what, i was so damn bored that i was gonna go and just try look for your house..but changed my mind...haha

 

whose? bobby bouches? yeah it aint that hard to get to.