I need help..
08-12-2004, 08:00 PM
#1
Guest
Posts: n/a
I need help..
Well, I have some autometer gauges that i would like to install but i dont know how to install them... I tried reading the instructions but they dont tell much. i have the autometer boost, water temp, and oil temp gauges. I know i have to tap into a whole bunch of stuff but i just dont know enough about cars to do it myself. If anyone would like to help me out and basically teach me how to do it so then i could help people in the future that would be great..
thanks juno
thanks juno
08-13-2004, 09:11 PM
#5
Registered User
iTrader: (4)
Join Date: Dec 2002
Location: Southern California
Posts: 2,176
Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco
You didn't
see my post? My driveway is su (your) driveway. Last night we installed some rear mounts, endlinks, and a sway bar. Today I installed a downpipe and two catbacks. Wiring stuff used to be my specialty, and I'm still good at it. I go back to work Monday, but the week after, I'm on leave (vacation) for the week. I have a compressor, ramps, jackstands, jack, tools, multimeter, and usually a few beers.
San
San
08-15-2004, 05:18 AM
#11
Registered User
iTrader: (4)
Join Date: Dec 2002
Location: Southern California
Posts: 2,176
Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco
To clarify,
one needs the proper sending units for any gauge. One needs to know the fittings are the right size (NPT, BNPT, etc). You can't buy "generic" gauges and expect them to work, unless you've done your homework. No offense.
San
San
08-19-2004, 05:21 PM
#15
Guest
Posts: n/a
can someone please tell me what fittings i need and what else i need to do this install.. And if someone helps me ill buy them a pack of beer and lunch... i just hate seeing all these car parts laying around.... Thanks -juno
Last edited by kscsentragtr; 08-20-2004 at 12:12 AM.