Help!! possible misfire
#32
Pr0n King
iTrader: (3)
Join Date: Nov 2002
Location: The Land of Rocks
Posts: 26,618
Car Info: Turncoat Turbo
Better yet (IMHO) is doing the resistor mod.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#33
Registered User
iTrader: (7)
Join Date: Dec 2002
Location: Flying on the H1 w/ 75 psi of compression on all 4 cyl
Posts: 2,859
Car Info: PnP VF30 w/ STi injectors Perrin intake walbro fuel pump w/ a TXS TBE
wow this isn't good. i did about 85% of the install the only thing from what im reading since everyone says this could be the problem is the egt sensor we did stick it back in there, but we removed the sensor from the tip i did this on the last 2 up pipes i did and had no problems at all if you need a resistor orly PM wrxboy i pretty sure he has a couple left and in the mean time i would recommend just trying disconnecting the harness for the egt sensor its the third one down and the smallest connector and see what happens. that should just throw a regular cell saying egt senor isn't reading or something along those lines.
#35
Registered User
iTrader: (4)
Join Date: Nov 2002
Location: Honolulu, HI
Posts: 3,462
Car Info: 2008 MB C350S Chip/Exhaust 268whp
Originally posted by mario
i did this on the last 2 up pipes i did and had no problems at all
i did this on the last 2 up pipes i did and had no problems at all
putting the EGT probe back into the uppipe is no problem, just the EGT probe will eventually fail because theres no cat in front of it. and when it fails your car will go into limp mode. so its just pretty much useless.
#36
Registered User
iTrader: (7)
Join Date: Dec 2002
Location: Flying on the H1 w/ 75 psi of compression on all 4 cyl
Posts: 2,859
Car Info: PnP VF30 w/ STi injectors Perrin intake walbro fuel pump w/ a TXS TBE
no problem boom i'll try and work on that. but yes i did put the egt sensor plug back in minus the sesor on the tip. So if this is whats causeing the limp mode he needs to pm wrxboy and see if he has any 2.2 om resistors left, and also unplug the egt sesor harness from the car so the ECU just thinks its mising instead of giving bad readings. hopefully that should work until he gets the resistor mod.
#37
Registered User
Thread Starter
iTrader: (8)
Join Date: Jun 2003
Location: yea! over there!
Posts: 823
Car Info: white 03 sedan
actually i went to a local radio shack today and i got the 2.2k ohm 1/2 watt resistor...no check engine light so far...hope it stays off...man, thanks for all the replies...i really appreciate everybody trying to help me out and stuff...most thanks to mario for doing most of the install.
Orly
Orly
Thread
Thread Starter
Forum
Replies
Last Post
Siper2
Engine/Power - non turbo (All non turbo Imprezas)
58
05-03-2006 08:38 AM
wonton2049
Engine/Power - EJ20T (pre-2006 WRX and JDM)
9
11-14-2004 03:25 PM