Hello I club!
I'm trying to do a swap on transmision and I was woundering if anyone knows where is a good place that does a job like that...also or if anyone did this before that can help me...of course I'll pay for ur service
Any help would be nice thank youuuu
Pm me or text,call
808-783-6569

 

bump...

 

Call Seth at import dynamics/sonic motorsports....

 

my auto is going bad…time for swap soon...

 

My auto to 6 speed was fairly straight forward. Your clutch master cylinder mounting location will be there on the fire wall. I don't know the specs on the leggy but ensure your rear diff ratio and trans match or it'll be bad day.

Interior wise you will need to source out the clutch pedal and parts and gearshifter and panel pieces around it.

 

Hmm I see..
So far I have the trans drive shaft and rear diff..also axle from legacy..
I heard about the speed sensor is different too...? Anyone has knowledge on this? Lol

 

Oh and of course I have the pedals and all interior parts..

 

Bump

 

What pedal assembly do you have? Not sure if the Legacy would fit. You would have to test fit that or do research on the legacy forums.

 

Not sure of the legacy pedal set but wrx and Sti mounting holes had to be notched a little. Also u will need a pedal adapter if you go DBW.

 

Seems like he has the complete legacy swap, so I'm guessing he has the pedal assembly also.

 

No I have Wrx pedals sets and wire harness and stuff
The only thing legacy are trans rear diff axle and drive shaft
Everything els I have Wrx stuff

 

ok…zoo back to 1 again…
i have no pedal sets now…anyone know anybody with left over trans stuff laying around?? ><

 

I know the best and easiest way. Sell the car. Buy one that is manual. Problem solved.

 

Actually I may have the clutch pedal assembly from a WRX. I got it in a purchase when I bought a WRX subframe for my Forester (planning WRX swap) but my Forester is already a 5-speed so I don't need it. I can confirm tomorrow if I have it or not if you still need it.