ScoobyBoy

iTrader: (4)

gday all. i was wondering if anyone knows the size of the nuts on the heatshield on the exhaust pipes, dp, midpipe, etc etc. or what size socket i need to unbolt all the nuts.
sorry if theres another thread about this.
thanks in advance.

Uncle Scotty

The entire exhaust can be assembled/disassembled with 12mm and 14mm tools....except for the o2 sensors...

ScoobyBoy

iTrader: (4)

thanks. i meant the heat shields that are on the pipe.

Uncle Scotty

Sorry...the heatshield bolts around the turbo are 10mm

Imprezer

iTrader: (9)

10mm and 12mm

DLUX WRX

iTrader: (1)

you'll need 10, 12, and 14mm tools.
quick tip.. you'll need a long 10 mm wrench to get to the heat sheild nuts on the passenger side. they are pretty deep in there.

ScoobyBoy

iTrader: (4)

sorry i guess im confusing everyone...i was actually talking about the heat shields that are on the actual pipes. the ones that are wrapped around the uppipe, downpipe, and midpipe.
thanks for the responses.

DLUX WRX

iTrader: (1)

i just took a look at my stock down pipe in my garage and the bolts are also 10 mm.
just curious... why do you want to take your heat sheilds off?

ScoobyBoy

iTrader: (4)

you serious they are 10mm too? they look so much smaller than it. ah well. i just wanted to see if the heatsheilds will fit around my new dp.

DLUX WRX

iTrader: (1)

what kind of down pipe did you get?

ScoobyBoy

iTrader: (4)

scoobysport. ugly piece of piping but it gets the job done.