Borla Hush Dyno Results
#16
I have not seen the flange end of the Borla exhaust so I'm not certain on this point, but I believe you could make it match-up to another down-pipe, provided the down-pipe flange isn't bigger than the Borla's flange. I built a custom 3" midpipe and mated it to a Bosal cat-back using a 3" flange and heavy-duty gasket and lock nuts. No leaks as of yet.
#19
Guest
Posts: n/a
Originally posted by xom
if only borla made it mate up with aftermarket downpipes. Hate to buy something and then start chopping it up. stupid donut gasket
if only borla made it mate up with aftermarket downpipes. Hate to buy something and then start chopping it up. stupid donut gasket
Check this thread on nasioc, scroll down most of the way though the thread where 'hatchy' has a picture and some comments about the adapter he has for a 3" downpipe.
http://forums.nasioc.com/forums/show...0&pagenumber=2
#22
Former Sponsor
iTrader: (39)
Originally Posted by mot
how is borla compared to the other exhaust systems? like HKS or Blitz?
The Borla units are pretty well made, they are not polished stainless only the tip is polished but they are 100% 304 stainless throughout.
The Borla's have a million mile warranty as well.
Mike
Thread
Thread Starter
Forum
Replies
Last Post
06scooby
Ongoing Projects
10
10-06-2006 10:47 AM
hezlok
Engine/Power - EJ20T (pre-2006 WRX and JDM)
3
05-02-2004 06:38 PM
mperalta
Engine/Power - EJ20T (pre-2006 WRX and JDM)
9
04-16-2004 02:45 PM