4eat problemo?
12-29-2003 | 07:55 AM
#31
Registered User
Joined: Mar 2003
Posts: 137
From: Elkton, Virginia
Car Info: 1998 Subaru Impreza L 2.2
i wonder if it has to do with the synthetic fluid being more "slippery".
-Charles-
12-29-2003 | 09:30 AM
#32
Thread Starter
VIP Member
iTrader: (14)
Joined: May 2003
Posts: 8,675
From: Wherever Sucks the Most
Car Info: 2003 WRX, 2008 Camry
Originally posted by ImprezaVA
I run conventional ATF and I still have the slippage. Slack, thanks again, that's what I was looking for.
-Charles-
I run conventional ATF and I still have the slippage. Slack, thanks again, that's what I was looking for.
-Charles-
12-29-2003 | 10:05 AM
#33
Originally posted by Sisqocqk
If we do an install day you guys will need to remind me on when and where. It'll take roughly an hour for each car to be done. When you buy the cooler be sure to get about 6ft extra of the same diameter tranny tubing (try tognottis) because the stuff in the box turns out to be a tad short and is too hard to work with. You'll also need a brass connector from a hardware store. Goto home depot and get a brass connector that can be used to connect two pieces of tranny line. maybe something that's 3" long in the same diameter with 2 extra hose clamps.
When you guys get the urge to have the install day post it and i'll get back to you. We'll need a basic set of MM sockets, two ramps and phillips & flat screw driver etc.
4eats unite!
eric
If we do an install day you guys will need to remind me on when and where. It'll take roughly an hour for each car to be done. When you buy the cooler be sure to get about 6ft extra of the same diameter tranny tubing (try tognottis) because the stuff in the box turns out to be a tad short and is too hard to work with. You'll also need a brass connector from a hardware store. Goto home depot and get a brass connector that can be used to connect two pieces of tranny line. maybe something that's 3" long in the same diameter with 2 extra hose clamps.
When you guys get the urge to have the install day post it and i'll get back to you. We'll need a basic set of MM sockets, two ramps and phillips & flat screw driver etc.
4eats unite!
eric
12-29-2003 | 10:31 AM
#34
Thread Starter
VIP Member
iTrader: (14)
Joined: May 2003
Posts: 8,675
From: Wherever Sucks the Most
Car Info: 2003 WRX, 2008 Camry
Originally posted by Slack
Cool thanks Eric, I talked to Dorifto he said we can do it at his house, I'm probably going to get a B&M tranny cooler off of Wingless Wonder whenever I get to another Sac meet(soon).:banana:
Cool thanks Eric, I talked to Dorifto he said we can do it at his house, I'm probably going to get a B&M tranny cooler off of Wingless Wonder whenever I get to another Sac meet(soon).:banana:
. Anyway, i like the B&M one too because it's solid and doesn't have the metal fins that bend easily like the hayden and permacool. i wish i would have gotten the B&M...oh well.When you and Mike get the urge and set a date i'll try my hardest to be there.
eric
Thread
Thread Starter
Forum
Replies
Last Post
