wth: My dipstick is showing low
#16
Registered User
iTrader: (3)
Join Date: May 2005
Location: Santa Rosa
Posts: 481
Car Info: 03 Sonic Yellow WRX Sport Wagon
To really know how much oil you've lost over time, you really should check it only when the motor is hot and has been shut off for aproximately 10 minutes. This gives the oil a chance to drain from the heads, etc and allows for thermal expansion. I believe this is what the owner's manual recommends and it's served me well.
When I first switched to Mobil-1 10-40 from dyno oil when the car was at like 7K miles, IIRC, I burned a bunch, but then it stopped consuming oil. I switched to Royal Purple and didn't like what I read about it so finally switched to German Castrol. I burn about half a quart between oil changes now (5K mile interval). I really like the GC.
When I first switched to Mobil-1 10-40 from dyno oil when the car was at like 7K miles, IIRC, I burned a bunch, but then it stopped consuming oil. I switched to Royal Purple and didn't like what I read about it so finally switched to German Castrol. I burn about half a quart between oil changes now (5K mile interval). I really like the GC.
#17
General Pimpin'
iTrader: (7)
To really know how much oil you've lost over time, you really should check it only when the motor is hot and has been shut off for aproximately 10 minutes. This gives the oil a chance to drain from the heads, etc and allows for thermal expansion. I believe this is what the owner's manual recommends and it's served me well.
When I first switched to Mobil-1 10-40 from dyno oil when the car was at like 7K miles, IIRC, I burned a bunch, but then it stopped consuming oil. I switched to Royal Purple and didn't like what I read about it so finally switched to German Castrol. I burn about half a quart between oil changes now (5K mile interval). I really like the GC.
When I first switched to Mobil-1 10-40 from dyno oil when the car was at like 7K miles, IIRC, I burned a bunch, but then it stopped consuming oil. I switched to Royal Purple and didn't like what I read about it so finally switched to German Castrol. I burn about half a quart between oil changes now (5K mile interval). I really like the GC.
Still burns oil. If I don't add any oil it will burn probably 1.5 to 2 courts in one change cycle.
But
#18
Registered User
iTrader: (8)
Join Date: Aug 2008
Location: San Mateo, Cali
Posts: 1,161
Car Info: 06 GMC Diesel
M1 Is garbage oil to begin with, Switch to some regular castrol or like stated above German Castrol 10w30 will do yeah fine 10w40 wouldn't hurt either.
Every time you change your oil add 4.5q's run the engine at Idle for 10 mins shut down for 10 and recheck, continue until the oil Is at the full mark. With castrol 10w30 or 40 you shouldn't burn more then 1q in 3-4k miles atleast I dont and I run my car hard with my 30r on a stock block.
GL
Every time you change your oil add 4.5q's run the engine at Idle for 10 mins shut down for 10 and recheck, continue until the oil Is at the full mark. With castrol 10w30 or 40 you shouldn't burn more then 1q in 3-4k miles atleast I dont and I run my car hard with my 30r on a stock block.
GL
#19
Forester Specialist
iTrader: (3)
Join Date: Jan 2003
Location: Sonoma County
Posts: 3,985
Car Info: '98/'04 Foresters (S & XT)
Interesting. We used to run Mobil 1, but recently changed to the Castol Syntec 0-w30 motor oil found at Auto Zone. This product differs from the others as it is made in Germany - and the Blackstone Lab analysis on the engine oil proves that it has far superior wear characteristics in our particular application.
We haven't lost a drop in oil consumption since switching. I can't say the same for the Mobil 1 - we had to top off at least twice between changes.
We haven't lost a drop in oil consumption since switching. I can't say the same for the Mobil 1 - we had to top off at least twice between changes.
#20
VIP Member
iTrader: (17)
Join Date: May 2005
Location: Sunnyvale, CA
Posts: 22,776
Car Info: '13 BRZ Limited / '02 WRX
M1 Is garbage oil to begin with, Switch to some regular castrol or like stated above German Castrol 10w30 will do yeah fine 10w40 wouldn't hurt either.
Every time you change your oil add 4.5q's run the engine at Idle for 10 mins shut down for 10 and recheck, continue until the oil Is at the full mark. With castrol 10w30 or 40 you shouldn't burn more then 1q in 3-4k miles atleast I dont and I run my car hard with my 30r on a stock block.
GL
Every time you change your oil add 4.5q's run the engine at Idle for 10 mins shut down for 10 and recheck, continue until the oil Is at the full mark. With castrol 10w30 or 40 you shouldn't burn more then 1q in 3-4k miles atleast I dont and I run my car hard with my 30r on a stock block.
GL
#21
Interesting. We used to run Mobil 1, but recently changed to the Castol Syntec 0-w30 motor oil found at Auto Zone. This product differs from the others as it is made in Germany - and the Blackstone Lab analysis on the engine oil proves that it has far superior wear characteristics in our particular application.
#22
Registered User
iTrader: (8)
Join Date: Aug 2008
Location: San Mateo, Cali
Posts: 1,161
Car Info: 06 GMC Diesel
Key word "Race Engine" as In an engine that has been perfected to get every oz of power with the longest life span possible... Sure M1 works for them as they need a super thin oil because of their tight tolerances, suby engines are not built like this. Look over on nasioc there have been quite a few threads about M1 being garbage for our engines, I'm not bashing M1 by any means just stating that It Is not the best oil to use with these cars, plus why spend 30+ dollars in just oil per oil change and then add 2+ quarts in between lol M1 aint cheap
#23
Registered User
iTrader: (2)
Join Date: Sep 2007
Location: Discovery Bay, CA
Posts: 1,569
Car Info: Evo X GSR, F250 Powerstroke Diesel
I run Mobil Synthetic 15w50 and literally don't burn a drop with forged pistons (with more piston to wall clearance than the factory block). So if your burning oil, there are underlying problems. Now if its a oil leak, you all good. Just fix the leak.
I think a quart per 1000 miles is just crazy, so you have to add 3 qaurts of oil in between oil changes?. Thats what my OEM block was doing with a piece of piston missing!
Subaru says burning 1 qt per 1000 miles is 'normal' and in my experience Subarus do tend to burn oil (all 3 of mine have burnrd - 84 wagon burnrd a lot, 02 bugeye burned a lot and my current 04 Sti burns a little)
Last edited by SR20steve; 08-06-2009 at 08:39 PM.
#24
VIP Member
iTrader: (17)
Join Date: May 2005
Location: Sunnyvale, CA
Posts: 22,776
Car Info: '13 BRZ Limited / '02 WRX
Key word "Race Engine" as In an engine that has been perfected to get every oz of power with the longest life span possible... Sure M1 works for them as they need a super thin oil because of their tight tolerances, suby engines are not built like this. Look over on nasioc there have been quite a few threads about M1 being garbage for our engines, I'm not bashing M1 by any means just stating that It Is not the best oil to use with these cars, plus why spend 30+ dollars in just oil per oil change and then add 2+ quarts in between lol M1 aint cheap
#27
Registered User
iTrader: (8)
Join Date: Aug 2008
Location: San Mateo, Cali
Posts: 1,161
Car Info: 06 GMC Diesel
Well yeah we all knew that one haha suby engines arent the strongest out of the box.
What I'm trying to say Is that If you use M1 you will burn more oil then usual due to It being quite thin compared to other synthetics.
#29
Registered User
iTrader: (2)
Join Date: Sep 2007
Location: Discovery Bay, CA
Posts: 1,569
Car Info: Evo X GSR, F250 Powerstroke Diesel
EXACTLY! You have a healthy motor sir. Having a turbo does not give you some reckless abandon for burning oil, lol. If you are burning oil....there is some level of problem with your motor. To what degree? Ehh? We have seen allot of high mileage beat on motors, lol. Hell my blown motor went almost 10k before I swapped in a new one, and it was still running when we swapped it.
#30
Registered User
iTrader: (3)
Join Date: Dec 2007
Location: pergatory
Posts: 794
Car Info: bici putas
truf.
it usually irks me when a product becomes guilty by association. The oil didn't necessarily *want* to burn away, but got sucked into the burning lifestyle by those no-good misfit piston rings, or turbo seals with bad dispositions.
easier to blame the oil than fix the bottom-end I guess
it usually irks me when a product becomes guilty by association. The oil didn't necessarily *want* to burn away, but got sucked into the burning lifestyle by those no-good misfit piston rings, or turbo seals with bad dispositions.
easier to blame the oil than fix the bottom-end I guess