asoka05

iTrader: (5)

Hey, anyone here in Fremont can pls give me a helping hand? You can ask for anything in return that is within reasonable.

So, turbo to intercooler hose (under the top intercooler) , came off. My car cant go over 3k RPM now.



*(the left arrow hose came off)

I am having a hard time trying to get the hose back into the turbo, without having remove the intercooler first.

Can someone here in Fremont come help me out real quick just to insert the hose back into the turbo?

thanks!

edit: removed intercooler. installed hose. won't go pass 4k RPM. Might be in limp mode. Will reset ECU tmr and report back!

LOL_VTEC

iTrader: (23)

Super easy taking off the intercooler! Hope this helps!

http://www.youtube.com/watch?v=C_Net...e_gdata_player

STi-owns-evo

iTrader: (4)

Just loosen the throttle body hose (next to your right arrow in the picture) as well as take out the 2 mounting bolts (on the left and right side of the TMIC). Wiggle the TMIC around to help you reach the y-pipe hose and you should be able to get it back on.

KrAzYkld

iTrader: (30)

Taking the intercooler off is easy, reinstalling it is the difficult part (especially with the stock Y-pipe) All I can say is take your time and be patient.

FXTbrah

iTrader: (17)

Taking it off with the stock Y pipe took me 45mins the first time. I was scared something was going to break. Stock Y pipes suck.

Atleast your car is boosting now :P

asoka05

iTrader: (5)

OK ! I took the intercooler off, and had a freaking hard time putting it back on !!

Even hurt my back! lol !

now, whenever I hit 4k RPM, the engine does not let me.

It just cut off, and it keep rev until 4K RPM only

asoka05

iTrader: (5)

everyone asleep !?

I'll try to reset ECU tmr and report back !

455h013

iTrader: (10)

lol Im in NY and awake, but I cant help.

deemon113

iTrader: (1)

Any luck with the ecu reset?

asoka05

iTrader: (5)

woke up super early to reset ECU

removed negative terminal on battery , step on brake for 10 seconds. (clock was reset, not sure if the ECU was reset?)

Still same symptom, won't go pass 4-5k RPM. man!

deemon113

iTrader: (1)

Does it build any boost until 4k rpms? Or just won't let you get there at all?

asoka05

iTrader: (5)

it does build boost. Boosting seems to be fine, but once the RPM hits like 4-5k RPM, it seems to have a fuel cut. No matter how hard I step on it, it doesn't go over the 4k RPM.

Also something happened earlier was, the CEL flashed for a few seconds when I am trying to hit above 4k RPM. Maybe misfiring? But the CEL went away as soon as I slowed down.

Right now, I can drive the car fine , just not above that said RPM.

deemon113

iTrader: (1)

Flashing CEL means misfire. Check the connections on the plugs and coilpacks again? Did you make sure to check the gap on the sparkplugs?

Jimboi

iTrader: (2)

Maybe need to remove both positive and negative terminals to reset. Just a thought lol

Lurk

iTrader: (10)

Pull the code from the CEL first and go from there. No point in guessing.

It would also probably be a good idea to replace the factory plastic intercooler Y-pipe with some Samco hoses and T-bolt clamps.