Generic Turbo Back set up
#1
Registered User
Thread Starter
iTrader: (7)
Join Date: May 2003
Location: BAIC
Posts: 552
Car Info: 03WRX=sold 08STI=newhotness
Generic Turbo Back set up
Any of you guys have generic turboback setups round here?
My idea was something like this:
http://www.mattrandolph.com/mattspec.htm
Essentially just 3" or 2.5" inch pipe w/ mandrel bends that you can get done at an exhaust shop, and some type of mass produced high flow cat & muffler.
Wanted to get opinions, maybe a ride with people with this setup? sound compared to other $$ setups?
My idea was something like this:
http://www.mattrandolph.com/mattspec.htm
Essentially just 3" or 2.5" inch pipe w/ mandrel bends that you can get done at an exhaust shop, and some type of mass produced high flow cat & muffler.
Wanted to get opinions, maybe a ride with people with this setup? sound compared to other $$ setups?
#2
Guest
Posts: n/a
Exhaust
Great pics. This is the type of exhaust system that most people on a budget or tight on funds could do.
Does the system have the O2 sensor after the cat also?
BTW, correct me if I'm wrong, you mentioned Mandrel bends and I only see the typical muffler shop bends on the exhaust.
Mandrel bends use a pretty expensive machine that keeps the same diameter throughout the bend. Hence, higher cost for the exhaust.
Muffler shop bends comperess the bends and makes for decreased diameter.
Does the system have the O2 sensor after the cat also?
BTW, correct me if I'm wrong, you mentioned Mandrel bends and I only see the typical muffler shop bends on the exhaust.
Mandrel bends use a pretty expensive machine that keeps the same diameter throughout the bend. Hence, higher cost for the exhaust.
Muffler shop bends comperess the bends and makes for decreased diameter.
#3
Registered User
Thread Starter
iTrader: (7)
Join Date: May 2003
Location: BAIC
Posts: 552
Car Info: 03WRX=sold 08STI=newhotness
Re: Exhaust
Originally posted by nixwrx
Great pics. This is the type of exhaust system that most people on a budget or tight on funds could do.
Does the system have the O2 sensor after the cat also?
BTW, correct me if I'm wrong, you mentioned Mandrel bends and I only see the typical muffler shop bends on the exhaust.
Mandrel bends use a pretty expensive machine that keeps the same diameter throughout the bend. Hence, higher cost for the exhaust.
Muffler shop bends comperess the bends and makes for decreased diameter.
Great pics. This is the type of exhaust system that most people on a budget or tight on funds could do.
Does the system have the O2 sensor after the cat also?
BTW, correct me if I'm wrong, you mentioned Mandrel bends and I only see the typical muffler shop bends on the exhaust.
Mandrel bends use a pretty expensive machine that keeps the same diameter throughout the bend. Hence, higher cost for the exhaust.
Muffler shop bends comperess the bends and makes for decreased diameter.
Thread
Thread Starter
Forum
Replies
Last Post