CEL with boost controller
11-24-2002 | 01:37 AM
#1
Guest
Posts: n/a
CEL with boost controller
Something happened the other day while I was driving on the freeway. Hit the "Hi Boost" on my profec. Car started to accelerate in 3rd, shift into 4th, BOV sounds off. Continue to accelerate, BOV sounds off again, boost drops and I get a CEL. Car runs normally all the way home. I check everything under the hood and it seems fine. Two hours later start up the car and no CEL. huh?
Any idea on what happened? My boost gauge read .12 kPa. When this happened. I am assuming it spiked and the ECU freaked out and went into limp mode. Any ideas would help.
T I A
-NORSE
Any idea on what happened? My boost gauge read .12 kPa. When this happened. I am assuming it spiked and the ECU freaked out and went into limp mode. Any ideas would help.
T I A
-NORSE
11-24-2002 | 01:47 AM
#2
Registered User
iTrader: (12)
Joined: Nov 2002
Posts: 18,369
From: Reno, NV
Car Info: 1993/2000/2001 GF4 mostly red
I'm not familiar with the profec, but it seems very likely that a spike is the cause. Do you have a code reader? You can probably still pull the code from the ECU if you haven't driven much since then.
Thread
Thread Starter
Forum
Replies
Last Post
mystilexzero
NorCal Classifieds
7
09-28-2015 01:37 AM
RavSpec
Vendor Group Buys/Specials
1
10-04-2004 01:03 PM
RavSpec
Vendor Group Buys/Specials
1
09-09-2004 11:42 AM
RavSpec
Vendor Group Buys/Specials
1
08-25-2004 04:26 PM
XwrxX
Aftermarket Forced Induction - Turboed factory NA engines
0
12-17-2002 08:14 AM