Help! Clunking sound after installing cusco sway bars
#1
Registered User
Thread Starter
iTrader: (6)
Join Date: May 2004
Location: Castro Valley, CA
Posts: 107
Car Info: 2005 CGM STi
Help! Clunking sound after installing cusco sway bars
I have installed cusco front and rear sway bars last week and now i have a clunking sound from the front of the car when i drive at low speeds, parking lot speeds when i go over bumps or turn (both left and right). I went under the car and retorqued every bolt involved during the installation (endlinks, swaybar mounts, AND the subframe) the clunking went away for one day, then suddenly came back again...any ideas on what it could be?
#4
Some folks suggest wrapping the bar with teflon tape. I tried that too but it was only a temporary fix.
Check around the subframe etc to make sure the bar is not able to hit anything when you hit a big bump.
Check around the subframe etc to make sure the bar is not able to hit anything when you hit a big bump.
#5
VIP Member
iTrader: (17)
Join Date: Dec 2003
Location: Fremont
Posts: 1,703
Car Info: 04 wrx, 05 Elise, 14 Impreza, 17 brz coming soon
mine was clunking in the rear due to the bolt coming out of the endlink/swaybar attachment. On one side my swaybar wasn't attached to anything and the endlink was just hanging there.
#7
Registered User
iTrader: (12)
Join Date: Nov 2002
Location: Reno, NV
Posts: 18,369
Car Info: 1993/2000/2001 GF4 mostly red
No other installs to the suspension? ALKs, strut tops, and spring/strut swaps are notorious for inducing clunks. If you haven't done that, try adjusting the setting on your sways to see if that helps. If it does, your endlinks could be contacting the sway bar where the spade end is flattened and the bar gets round again.
Thread
Thread Starter
Forum
Replies
Last Post
rubberbulletz
Used Aftermarket Car Parts For Sale
2
07-31-2011 10:49 PM
hayakunai
Suspension, Handling, and Brakes
3
10-10-2006 03:12 PM
wvinfernovw
Suspension, Handling, and Brakes
2
03-18-2006 11:39 AM